Any way to have more analog inputs or ADAT-in option?

[bvog]

This one goes out to anyone knowing how to achieve this:

I'm planning to use the Receptor Pro for several FX on several analog ATB console inserts. Problem is, there's not enough analog ins supplied with the Receptor and also no ADAT-in allowing me to go: analog console -> A/D -> ADAT-in (Receptor) ADAT-out -> D/A -> analog console

To go via DAW and back to the console is not an option as well as going via uniwire, since this would make a nonsense set-up.

I am wondering wether one of the following could work:

1) Using one of the USB connections to run a seperate audio interface with enough anlog I/O - I wouldn't like this one too much, but if it only worked:-)

2) Since there's already converters and an ADAT-out aboard it is most likely that ADAT-in is already supported by the built in hardware. To add an ADAT-in and use an external AD/DA/ADAT in conjunction with the Receptor would be my favorite. Anyway, getting these additional inputs coded into Receptor's source code could be quite a hazzle.
I would appreciate if anyone at Muse could explain what obstacles there are in when going this way.

Maybe Muse didn't implement this because no one was likely to be asking for it. But I do ask, and my decision on purchasing one or two Receptors depends solely on this question.

And if you finally could get my UADs running inside Receptor I'd buy even more - sorry, just dreaming...

...anyone?

Best regards
Boris