i've purchased Stylus RMX 1.2 and installed it successfully on a Receptor Pro Jr.
After registering with Spectrasonics, I logged into their support site to download updates, etc. On the site, i found a StylusRMX.dll at version 1.5.1c especially for the Receptor.
Do I simply replace the 1.2 dll on my receptor with this file to upgrade?
I reason I ask is that I various discussions about how an RMX on the Receptor has failed for them.
Any help is appreciated.
Stylus RMX 1.5 status
-
- KVRist
- 209 posts since 25 Jun, 2004 from New England
-
- KVRist
- 68 posts since 22 Aug, 2007
Hi
Its just advice - but I'd be careful about just replacing the .dll.
I had to re-install RMX Stylus three times to get it to work. I'll be honest and say while Muse were helpful (and polite) in discussing licensing issues (my receptor was pre-owned) Spectrasonics weren't that helpful. Even now, I still haven't worked out how to 'start a loop'(ie press the play button) from the front panel. Not sure if this is possible...
I reckon you may have to re-install the dll file if you do move it across.
Its just advice - but I'd be careful about just replacing the .dll.
I had to re-install RMX Stylus three times to get it to work. I'll be honest and say while Muse were helpful (and polite) in discussing licensing issues (my receptor was pre-owned) Spectrasonics weren't that helpful. Even now, I still haven't worked out how to 'start a loop'(ie press the play button) from the front panel. Not sure if this is possible...
I reckon you may have to re-install the dll file if you do move it across.