Hello, I love my receptor - most of the time. The other day in rehearsal I tried to pull up a multi that I had just finished programming a few minutes earlier. I used just a couple of plugs -Kontakt 2 being one of them. But the front panel just said loading…. After a minute I went to investigate by pulling up Remote from my laptop. It turns out Kontakt was giving a pop up window message (I don't remember what) and it was waiting on my response before it finished loading and would become playable.
Q: Is there a way to click "ok" on a pop up window from the fount panel? I don't hook up a laptop remote live so if the above happened I would be screwed in the live situation.
Thanks for the response,
Yates
Getting past Kontakt 2 pop up window from front panel
-
- KVRer
- 10 posts since 12 Feb, 2007
Last edited by theyateser on Sat Dec 08, 2007 8:24 pm, edited 1 time in total.
-
- KVRian
- 691 posts since 13 May, 2004 from Silicon Valley
Hi Yates,
I don't think there is a way to do this.
I think your best bet is to investigate the source of the problem reported by the dialog. Most likely it is a sample that Kontakt can't find (or some such thing). If you resolve this, then resave your Kontakt instrument, you should be OK to load the instrument without a dialog the next time.
Hope that helps, Regards,
Kevin L
I don't think there is a way to do this.
I think your best bet is to investigate the source of the problem reported by the dialog. Most likely it is a sample that Kontakt can't find (or some such thing). If you resolve this, then resave your Kontakt instrument, you should be OK to load the instrument without a dialog the next time.
Hope that helps, Regards,
Kevin L