Albino 3 acting weird
-
- KVRist
- 309 posts since 11 Sep, 2005 from Virginia
Has anybody experienced the following problem with Albino 3 on Receptor: From the Albino UI, I save an Albino layered patch as a Receptor Source Patch or a Receptor Single Patch. Later I refer to the patch by making a program change from my keyboard while Receptor is set to receive program changes via "Single" or "Source". Receptor sends the patch to Albino 3, but Albino 3 seems to always go to "Bass Molecules" or another Albino 3 patch that is not related to my saved patch. Ugh!
-
Rick@MuseResearch Rick@MuseResearch https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=18273
- MUSEician
- 350 posts since 23 Mar, 2004
Phil,
Here's a test I ran.
1. Load an Albino 3 layer patch, save this as a source patch.
2. Repeat this step a few more times.
3. Send program change of just use a mouse to select the Receptor patch.
Result: The sound changes to what was saved but the layer text does not reflect what is loaded.
Here's a test I ran.
1. Load an Albino 3 layer patch, save this as a source patch.
2. Repeat this step a few more times.
3. Send program change of just use a mouse to select the Receptor patch.
Result: The sound changes to what was saved but the layer text does not reflect what is loaded.
Rick
Muse Research
Muse Research
-
- KVRist
- Topic Starter
- 309 posts since 11 Sep, 2005 from Virginia
Rick,MaxReverb wrote:Phil,
Here's a test I ran.
1. Load an Albino 3 layer patch, save this as a source patch.
2. Repeat this step a few more times.
3. Send program change of just use a mouse to select the Receptor patch.
Result: The sound changes to what was saved but the layer text does not reflect what is loaded.
Try picking about five different multi-layered Albino 3 patches and saving them to about 5 different Receptor Source Patches. Then try switching patches using the Receptor Source Patches and see if the real patch comes up or is it a different sounding patch with a similar name? Did it drop any of the Albino 3 layers?