While I was trying parallel compression I notice that send works differently depending on rack's slot.
Infact when i move down the send from slot 3 to slot 4 there's an evident difference of volume. slots 4,5,6 exit on other rack with some decibel less.
It's clearly audible but I've tryed with an analyzer too it seems there're no spectral differences, just volume.
I don't know if it's a bug, but actually I don't think so... just curious about this...
send works differently depending on rack's slot
-
- KVRist
- 124 posts since 24 Oct, 2005
-
- KVRian
- 1372 posts since 21 May, 2004 from Serbia
There are two types of slots in the Racks - pre and post fader slots. There's a blue arrow/triangle at the left side of the slots which shows which slots are which - the ones above the arrow are pre, and the ones below are post fader. You can freely move this arrow if you need more pre or post fader slots (by default it is between slots 3&4). Note that you can see this arrow only when a rack is expanded.
-
- KVRist
- Topic Starter
- 124 posts since 24 Oct, 2005
thank you very much.