how do i make the second osc to use the second or 3rd adrs env ? i tried linking the volume from the second osc to a second adrs env but it still uses the first adsr.
how do i do this ?
How to make the second osc have a different adsr envelope ?
-
giorgiomartini giorgiomartini https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=161733
- KVRist
- 335 posts since 1 Oct, 2007 from Berlin
If i have two oscilators each one in one independent channel, the second oscilator amplitude envelope is always controlled by the first adsr env.
how do i make the second osc to use the second or 3rd adrs env ? i tried linking the volume from the second osc to a second adrs env but it still uses the first adsr.
how do i do this ?
how do i make the second osc to use the second or 3rd adrs env ? i tried linking the volume from the second osc to a second adrs env but it still uses the first adsr.
how do i do this ?
-
- u-he
- 30215 posts since 8 Aug, 2002 from Berlin
You see the selctor below "Pan" and above "Vol" in the mixer below each column of the Grid? It says "Env1". You can make each of the four channels in the Grid use a different envelope, out of Env1/2/3/4 and Gate.
Cheers,
Urs
Cheers,
Urs-
- u-he
- 30215 posts since 8 Aug, 2002 from Berlin
You can of course also set oscillator volume to 0 and add some Env2 there, right in the oscillator. But that doesn't change the fact that the whole channel is additionally controlled by the envelopes in the Voice Mix section.
-
giorgiomartini giorgiomartini https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=161733
- KVRist
- Topic Starter
- 335 posts since 1 Oct, 2007 from Berlin
Thanx urs, its a plesure to have replies directly from you ;d thank you for this great plug.