Every time I upgraded to a new version/release (A,B,C etc.) and reloaded a project file the audio loops are out of sync and if I go back to the MuLab version that created the project everything is fine. The loops are created from Rex in Reason with the correct Time and BPM. I can't figure it out.
I just purchased the 2.04 (when I saw the 2.5/3.0? ReWire upgrade feature I could not resist any longer) and I am a little concerned that this will occur every time...it could be a little hell indeed.
Thanks
Audio loops out of sync
-
- KVRAF
- 5573 posts since 30 May, 2006 from Hollow Earth
ABEFLGMOPPRRST 
-
- KVRAF
- 13862 posts since 24 Jun, 2008 from Europe
Is that using audio files or using samples?
Could you please also describe the problem in more detail.
Could you please also describe the problem in more detail.
-
- KVRAF
- Topic Starter
- 5573 posts since 30 May, 2006 from Hollow Earth
Well, it's a Percussion Audio file 1 Bar long at 120BPM 4/4.mutools wrote:Is that using audio files or using samples?
Could you please also describe the problem in more detail.
Here is what I do:
Run MuLab v.2.00 or whatever
New Project : 4/4 120-BPM,
Rack A > New Audio part (1 BAR)> Insert Audio Clip (1 BAR)
Rack B > New Sequencer part (1 BAR)
Rack B > first slot mixer Strip insert Synthia
Write few notes in the sequencer and close it.
Hit Play .... everything's fine.
Save Project and quit.
Load a newer version of MuLab like.. 2.02 or 2.04
Open that Project
Hit Play....Audio and Sequencer out of sync! Same Audio File.
Back to the same MuLab version: Open file > Hit Play = No Problem
The same Audio file was tested in Energy-XT, Live and FL and reloaded in Reason. No problem.
I tried other Audio files and got the same results. I find this unusual because I went through the forum and I didn't spot anything like this.
I can send you the Audio file if you need. Just tell me where to send it to.
I know you fix anything soon or later, so thank you in advance.
ABEFLGMOPPRRST
-
- KVRAF
- 13862 posts since 24 Jun, 2008 from Europe
Some more questions:
-> Are you on Windows or OSX?
-> Could it be that the audio setup samplerate differs between those different MU.LAB versions?
-> If you accurately research the above example you gave, then which part is playing at another speed: the audio part or the sequence part?
-> Are you on Windows or OSX?
-> Could it be that the audio setup samplerate differs between those different MU.LAB versions?
-> If you accurately research the above example you gave, then which part is playing at another speed: the audio part or the sequence part?
-
- Hun #3
- 4265 posts since 25 Mar, 2002 from A quaint little village just south of Hamburg, Germany
quickie off the top of my head - does saving the file again in the more recent version solve the problem?
Marco
Marco
-
- KVRAF
- Topic Starter
- 5573 posts since 30 May, 2006 from Hollow Earth
Damn Right! It was the samplerate. Now I can have a peaceful New Yearmutools wrote: -> Could it be that the audio setup samplerate differs between those different MU.LAB versions?
Thank You.
(BTW Marco I did not try it because I got to the Samplerate first but thanks)
ABEFLGMOPPRRST