Hi,
I use Artillery in Logic 8 but i've a problem.
The volume increase when I use artillery.
Example, i've a bus with my drums and in the sidechain section of artillery, i select this bus.
The problem is : the volume increase on the drums.
How can I use artillery FX without increase the volume on the part who is used in artillery ?
Best,
Vincent
Artillery in Logic 8
-
Digital Network Digital Network https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=161620
- KVRer
- 21 posts since 30 Sep, 2007
-
- KVRian
- 1339 posts since 27 Apr, 2007
Hello Digital Network,
if you run a signal into Artillery and no effect is active, the signal will run through. If the original track is also running, you end up having 2 tracks playing exactly the same. Thats why you should turn down the volume of the original track to 0. Now the Instrument track (with Artillery) is your drum track. Here you should make the mixing, eq's etc.
If you have volume problems when an Artillery FX becomes active adjust the volume with Effect Level parameter in the effect.
Hope this helps,
Robert
if you run a signal into Artillery and no effect is active, the signal will run through. If the original track is also running, you end up having 2 tracks playing exactly the same. Thats why you should turn down the volume of the original track to 0. Now the Instrument track (with Artillery) is your drum track. Here you should make the mixing, eq's etc.
If you have volume problems when an Artillery FX becomes active adjust the volume with Effect Level parameter in the effect.
Hope this helps,
Robert