Gotta love the Uhbiks
Uhbik-F: Finer Automation of Manual Phase
-
- KVRAF
- 1895 posts since 13 Oct, 2002
One place where I feel there could be some improvement is the automation of the Uhbik-F's Phase parameter when the clock is set to Manual because very small incremental changes cause some pretty dramatic effect changes. I'd really like to be able to remap a smaller range of the Phase parameter to a larger range of the automation, to make it easier to handle subtle manipulations.
Gotta love the Uhbiks
Gotta love the Uhbiks
-
- u-he
- 30215 posts since 8 Aug, 2002 from Berlin
Have you tried setting "times" to 1 or 2? - The "times" knob (above phase knob) determines the number of cycles that the phase knob goes through in manual mode. If it's set to 1.00, then there's only one cycle throughout a full rotation of the phase knob.
Oh... and shift-drag (or click-drag on the lower rim of the knob) allows for fine control...
Hope this helps,
Urs
Oh... and shift-drag (or click-drag on the lower rim of the knob) allows for fine control...
Hope this helps,
Urs