How to apple a pitch flick to a 4oscillator bass patch.

[jamie8286]

Hey guys just wondering how i can apply a pitch flick at the start of a bass patch i have made. I have done it for one oscillator by apply a spiky MSEG to the tune of the oscillator this gives it a knock at the beginning this is what i am after (also could be done with env2 i guess) But then how can i apply it to the rest of the oscillators there isnt any global tune knob as such or i could have put it on that. If i route them all via the mod matrix i will run out of modulation space.

Are there any plans to make more room in the mod matrix? or apply one modulation to more then one target in the new beta version? This would make things a lot easier i guess

thanks Jamie

[Mans]

Why not simply apply the envelop to the other oscs tune knobs?

[bmrzycki]

If you already have the MSEG set the way you want, just set the modulation target for Tune to all be MSEG1. Any mod source can be applied to 1 or more targets at the same time and with varying amounts of modulation on each destination knob. No need for the mod matrix in this case.

[Cyoon]

the new 2.5 version got an extended mod matrix yes..

you even could use the other msegs for the other osc or even the same mseg on the others osc tune..

good luck..

could you maybe provide a sample? sounds interesting..

[jamie8286]

Hi thanks for the reply's I didn't realize i could assign it with the mod knob on the oscillator section got it sorted now. Only just starting to learn zebra iv had it a while but not had time to learn it properly (should of read the manual better ) I'll try to get a sample up when i get a bit further on with the patch just making some sort of phat kick bass or lead sound not sure yet.

cheers Jamie