KVR Audio

Fragile_Frankie · Post by **Fragile_Frankie** » Wed Nov 18, 2009 7:59 pm

Starts at 0:52 seconds

Fragile_Frankie · Post by **Fragile_Frankie** » Thu Nov 19, 2009 10:18 pm

Bump.

larm · Post by **larm** » Thu Nov 19, 2009 10:58 pm

I hear a standard VA-saw patch with a fast envelope, no attack and sustain, just some decay to keep the env up, also map filter to cutoff (low resonance) then add some delay with low feedback, a short room reverb and some distortion to saturate the attack more, i.e. create more overtones..

Much of the character of the sound is due to detuning a second saw osc about +10 cents

I think it is easier to recreate if you aim for a similar sound to the low notes at 2:02-ish

MOK19 · Post by **MOK19** » Fri Nov 20, 2009 3:31 am

^ yeah, that!

xybre · Post by **xybre** » Fri Nov 20, 2009 6:29 am

I bet if you took a brass preset, and turned the attack and sustain to 0, a short bit of decay, and then had it detune using an LFO or envelope just a bit you'd end up with something very close.

Put some distortion, preferably something digital and harsh, no tube saturation here. Then a little bit of room reverb.

I kinda get the feeling it's an FM sound, so if you have an FM synth with brass presets start there, but if not, I think as mentioned a regular VA should work too.

Also +1 Suicide Commando.

Fragile_Frankie · Post by **Fragile_Frankie** » Fri Nov 20, 2009 4:18 pm

All right thanks everyone, I'll try all of that.

Lead sound