When using MIDI-based control (sending notes to MDrummer on Channel 1-9 to trigger Beat and Break), a Break will repeat and be played when a Beat has been signaled to play. It doesn't happen every time the song passes the section, but will happen sporadically. For example, the MIDI information passed is:
C1 C1 C1 C2 C1 C1 C1 Notes
Beat Beat Beat Break Beat Beat Beat Intended Outcome
Beat Beat Beat Break Break Beat Beat Occasional Error
Is there any setting available to correct this issue? I am currently using the demo to determine how it will perform in FL Studio.
Paul
Problem in FL Studio
-
- KVRer
- Topic Starter
- 9 posts since 3 Dec, 2004
Another observation; different behavior occurs if the Sequencer option is enabled (Rhythm Editor/Additional/Sequencer). Without the Sequencer option, behavior noted in my first post occurs. With the Sequencer Option enabled, the following occurs:
C1 C1 C1 C2 D1 D1 D1 - NOTE
Beat1 Beat1 Beat1 Break Beat2 Beat2 Beat2 - Expected
Beat1 Beat1 Beat1 Break Beat1 Beat2 Beat2 - Behavior
It plays as expected sometimes, but often the unexpected behavior occurs.
C1 C1 C1 C2 D1 D1 D1 - NOTE
Beat1 Beat1 Beat1 Break Beat2 Beat2 Beat2 - Expected
Beat1 Beat1 Beat1 Break Beat1 Beat2 Beat2 - Behavior
It plays as expected sometimes, but often the unexpected behavior occurs.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Aaaha damn it, I have already one report of such a behaviour. Unfortunately I wasn't able to simulate it yet. Could you send me a project, so I can check by here?
