Digital peak meter Automation output problem

[lillos]

I notice that the automation output of the DPM has very low resolution. Im talking about timing or horizontal resolution and not vertical. To make this easy to understand: The time between two consecutive automation points is almost 100 miliseconds. That means that a lot of information gets totally lost. For example a peak could ocupy less than 10 miliseconds and with the resolution of DPM it would be impossible to record such peaks.
I think that the problem is the plugin itself and it has nothing to do with the resolution of cubase that Im using. I can input automation points with very big timing accuracy, less than a milisecond. Its blue cats DPM that cannot output acceptable timing resolution.

Try to record some automation from the output automation and you will see what I mean.
It should be that the the timing resolution should be at least 1ms to have some usable results.

[Blue Cat Audio]

See our answer in the original thread:
http://www.kvraudio.com/forum/viewtopic.php?t=275395