Hi All,
I'm using my receptor through UniWire controlled by Logic Pro 9.
I'm using lots of Arpegiators but my Receptor keeps going back to Internal Tempo Source. I've changed and re-saved the Multi-patches over and over but arrgghh.
Any help????
x
Not remembering UniWire Tempo Source
-
- KVRist
- 31 posts since 13 Aug, 2008 from Sydney, Australia
-
Kevin@MuseResearch Kevin@MuseResearch https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200693
- MUSEician
- 188 posts since 11 Feb, 2009
Hey, did you try saving your LOGIC session after re-saving your Multi as well? Try that and see if it remembers.
- Kevin
- Kevin
-
- KVRist
- Topic Starter
- 31 posts since 13 Aug, 2008 from Sydney, Australia
Hi Kevin,
Yeah, I save about 1000 times per minute. I think I probably Apple-S in my sleep.
I have patches setup for each project and all other setting and communication work fine, it just always goes back to an internal clock source. I usually have the internal tempo set to match but it's still frustrating. It's easy enough to change it back each time but it's an annoying curiosity.
Yeah, I save about 1000 times per minute. I think I probably Apple-S in my sleep.
I have patches setup for each project and all other setting and communication work fine, it just always goes back to an internal clock source. I usually have the internal tempo set to match but it's still frustrating. It's easy enough to change it back each time but it's an annoying curiosity.
-
- KVRist
- Topic Starter
- 31 posts since 13 Aug, 2008 from Sydney, Australia
oops. Just realised I didn't have my system specs in my signature, which I now do.
Receptor PRO 1.0 Komplete : 1.7.20080616 :2GB RAM : 500GB HDD