I'm using Zebrify with a very simple setup. I'm modulating the incoming audio with a lfo on the filter cutoff and volume. I've got the LFO set to user waveform and defined a sequence with 4 lines and the speed set to 1/16. The sequence is set to emulate the pumping effect of a sidechain - so instead of using compressors I just modulate the filter and envelope with a nice slope, and it's a nice "cheat" I think. Anyway, the problem is that the LFO gets out of phase. I can start my sequence at one point and it will modulate correct, but if I stop and start play again (from the start), it'll shift the phase - making the modulation happen on the off-beat instead of on the on-beat. I've tried both settings for the LFO (gate and free), but neither gives me a usable result. Is this an expected behaviour or a bug?
I'm using Zebra 2.5 btw.
Zebrify - no bug
-
twolegstoneworks twolegstoneworks https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=7585 - KVRian
- 1426 posts since 12 Jun, 2003 from Denmark
Last edited by twolegstoneworks on Wed Mar 03, 2010 10:03 pm, edited 1 time in total.
-
- KVRAF
- 13133 posts since 7 May, 2006 from Southern California
You can put the LFO in gate mode and then route a midi track to Zebrify to retrigger the LFO via midi notes.
-
twolegstoneworks twolegstoneworks https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=7585
- KVRian
- Topic Starter
- 1426 posts since 12 Jun, 2003 from Denmark
Ahh.. ofcourse..justin3am wrote:You can put the LFO in gate mode and then route a midi track to Zebrify to retrigger the LFO via midi notes.
thanks for reminding me 