I'm finding that when I open ACE via the audio unit bridge in Logic 64, the automation parameter names are all gummed up. In particular, under Logic 32, the parameters are grouped in a two-level hierarchy, with for example VCO2 at the top level and all of VCO2's parameters underneath it. In Logic 64, all the parameters appear at a single level, with the exception of a single folder that contains a few parameters. And the identity of that single folder changes from run to run -- it might be LFO1 and then VCF2 the next time. Very odd. It's quite difficult to work with it in this form, because many of the parameters have the same name and are only distinguished by what their 'parent' is.
-Luddy
Automation parameter names in ACE under Logic 64
-
- u-he
- 30216 posts since 8 Aug, 2002 from Berlin
Yo, that must be a bug in the bridge then.
I'm very keen on delivering 64-bit support though. It's a bit more difficult for me on Mac than on Windows, but with some luck I'll be getting there in a few months.
Urs
I'm very keen on delivering 64-bit support though. It's a bit more difficult for me on Mac than on Windows, but with some luck I'll be getting there in a few months.
Urs