It seems that Side-Chain can only be done in the MSA. It this correct?
If so, could the Sends made in such a way to target a Rack and further a Slot in which effects, such as the Compressor, would show up in the expanded target menu?
In this case the compressor will have input A and B.
Is there something different in the first Slot of a receiving Send Rack that is different than the following Slots? Like mix-down of several audio signal?
If not, then, it could be possible to have Sends targeting different Slots...
Rack A
(Slot1)Drum
(Slot2)Send > to Rack B(Slot2) Compressor Input-2b
Rack B
(Slot1)Synth
(Slot2)Compressor Input-2a
This Slot targeting could open some more front control rather then getting in the MSA for usual workflow.
Is this ever possible?
Side Chain in the Rack?
-
- KVRAF
- 5573 posts since 30 May, 2006 from Hollow Earth
ABEFLGMOPPRRST 
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
It's not planned.
Because you can do it in the MSA. In fact you can do everything in the MSA.
And it's especially the purpose of the racks/rackdesk to offer a simple interface.
Because you can do it in the MSA. In fact you can do everything in the MSA.
And it's especially the purpose of the racks/rackdesk to offer a simple interface.
-
- KVRAF
- Topic Starter
- 5573 posts since 30 May, 2006 from Hollow Earth
Got it! Thanks.mutools wrote:It's not planned.
Because you can do it in the MSA. In fact you can do everything in the MSA.
And it's especially the purpose of the racks/rackdesk to offer a simple interface.
ABEFLGMOPPRRST