Minimal Techno synth sound with Zebra 2.5

Official support for: u-he.com
Post Reply New Topic
RELATED
PRODUCTS

Post

Hello,

I'm trying to reproduce this synth sound with zebra. Could someone help ? I've came a lil close but not enough :?

http://rcpt.yousendit.com/899146381/33c ... 35dd35d4c2

Post

Start by loading the Zebra patch 'initialize'

- Add a second oscillator and adjust the tune knob up to 7.
- Add VCF1 below the two oscillators (so it filters the 2 oscillators) and adjust the cutoff to 80.
- Click on VCF1 cutoff modulation 'circle' and select Env2. Adjust the amount of modulation to 74.
- Go over to Envelope1 and adjust the attack to 4.
- Go to Envelope2 and adjust the attack to 14. Also adjust Envelope2 sustain down to 12.

Play C, D, E and adjust to your taste. The sound is defined by two oscillators, one tuned a seventh above the other. Some of the other sawtooth waveforms might get you a little closer.

Or am I way off base here?
Fig Newton: The force required to accelerate a fig 39.37 inches per sec.

Post

Thanks for your answer, it is actually a good way to approach the matter. It's close but like you said i need to find the right oscillator library. Also i'm tweaking the glide (1 & 2) and i'm getting somewhere... hopefully i'll find something !

Post Reply

Return to “u-he”