Hello again.
Is there any problem with modulation wheel?
I've changed funeral bass by adding LF0 generator and attaching mod wheel event to it.
When I focus into the instrument itself, it responds to mod wheel changes.
When I focus into the rack with the instrument, it doesn't.
Mod wheel events get recorded, but they have no influence to played instrument.
Is it an issue or am I doing something wrong?
All the time the Pitch wheel works well.
The similar issue is probably with any controller (I have tested controller 20)
I am closer and closer to master MULAB :)
It is very handy music application.
issue with mod.wheel?
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
How did you setup the modulation to LFO mapping?qba wrote:I've changed funeral bass by adding LF0 generator and attaching mod wheel event to it.
When I focus into the instrument itself, it responds to mod wheel changes.
When I focus into the rack with the instrument, it doesn't.
Using 'global span' or 'module span'?
FYI: When you map a MIDI controller with "Global Span", then the mapping is always active. When you map a MIDI controller with "Module Span", then the mapping is only active when the respective module is focussed.
-
- KVRer
- Topic Starter
- 10 posts since 28 Jun, 2010
I have track with bass and modulation wheel events.
Track has the target set to rack with bass instrument.
When I play the track, bass inside the rack does not respond to midi control event (modulation wheel).
I've mapped the instruments' fifth parameter of sixteen to lf0 volume control. While adjusting this param the lf0 changes the amplitude, so it is done properly.
The fifth parameter is controlled by mod wheel events (global span, min 0.5, max 1.0, any channel).
When I manually control this param from the main instruments' control panel, it works too.
But during track playing, the event track has no effect to the sound produced...
Maybe I have messed something up with mappings...
Track has the target set to rack with bass instrument.
When I play the track, bass inside the rack does not respond to midi control event (modulation wheel).
I've mapped the instruments' fifth parameter of sixteen to lf0 volume control. While adjusting this param the lf0 changes the amplitude, so it is done properly.
The fifth parameter is controlled by mod wheel events (global span, min 0.5, max 1.0, any channel).
When I manually control this param from the main instruments' control panel, it works too.
But during track playing, the event track has no effect to the sound produced...
Maybe I have messed something up with mappings...
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
MIDI controller mapping only works on MIDI input, not on sequenced events.
If you want to automate that parameter, simply automate the parameter itself.
Hope this helps.
If you want to automate that parameter, simply automate the parameter itself.
Hope this helps.