I got your PM question - however I could not send a reply as you have set to not accept PM... - Sorry, the person you are trying to Private Message has chosen not to accept Private Messages. - ...so I qoute my answer here.
Hi Mistheria!
Glad to read your message - however please note that I am no official Cantabile support - I am just a fan doing the best I can whenever possible.
Switching subsessions via program change should work.
I am not sure what you refer to with CC146... that does basically not exist as continuous controllers are in the usual midi range of 0..127...
Try the following:
- Go to "Setup Tab" and open "MIDI Assignments"
- send any program change by pressing one of your buttons
> You will see Controller: "Progam xxx on..."
- choose form popup Assign to the entry "Subsessions - Load Subsession"
> The Controller will change to "Program Change on..."
- Now click "Assign" button, then "Close" button.
This should work.
Some additional troubleshooting hints:
Do not forget to click "Assign" button before closing the MIDI Assignments dialog box.
Do not select form popup Assign to the entry "Subsessions - Load Specific Subsession". This creates a 1:1 assignment from any program change command to one specific subsession in Cantabile
Make sure you have set program numbers with your subsessions.
Hope this helps.
If not feel free to reply.
Good luck for your performance!
TiUser.
