u-he

ViktorW · Post by **ViktorW** » Mon Dec 20, 2010 12:14 pm

Dear Urs,
been using ACE for a few weeks now, and have played with Bazille 0.4 today, and I have the same problem all the time. Well not really a problem, but the cables are always in the way. Often I can't read parameters because they're blocked from view, and I lose clear overview over my patch.

It would be nice if the cables, you know, went out of the way of the mouse pointer when I approach them. Or become partly transluscent, or something. Is that maybe something you would consider implementing some time?

And some concluding praise: Your creations are hot stuff!

Cheers

vinz89 · Post by **vinz89** » Mon Dec 20, 2010 12:24 pm

Hi man!
Right click on any input of any cable and go down the scrolling menu, there are options for the cables view: my favorite is "thin and see thru" you can so make the cables transluscent so that you can see the values and names of the parameters...
Cheers
Vinz

ViktorW · Post by **ViktorW** » Mon Dec 20, 2010 12:35 pm

Damn, I should have taken a closer look at what's already there.
Always good to check out the manual, right?
"thin and see through" is indeed perfect.
Thanks, man, and sorry for the redundant thread.

Cheers

Urs · Post by **Urs** » Mon Dec 20, 2010 1:22 pm

(it's actually not in the manual yet)

Mushy Mushy · Post by **Mushy Mushy** » Mon Dec 20, 2010 1:23 pm

Urs wrote:(it's actually not in the manual yet)

Sure it is, it's just in thin and see through font

Urs · Post by **Urs** » Mon Dec 20, 2010 1:27 pm

Mushy Mushy wrote:
Urs wrote:(it's actually not in the manual yet)
Sure it is, it's just in thin and see through font

wonshu · Post by **wonshu** » Mon Dec 20, 2010 2:46 pm

Mushy Mushy wrote:
Urs wrote:(it's actually not in the manual yet)
Sure it is, it's just in thin and see through font

u-he

KVR Audio

Cables that "go out of the way"