FR for midicurve - change preset via PC

[-PIKU-]

i need to change preset by sending PC messages to the plug.. how can i do?

[insertpizhere]

it only had one program, but only took a couple minutes to change. now has 128 and listens to program change.

http://thepiz.org/pizmidi/midiCurve.zip

i haven't really tested it so let me know if there are any problems.

[-PIKU-]

mmh.. no preset changes when i send pc messages

another request: possibility to convert 10bit PB messages to cc

[insertpizhere]

hmmm, it works if the program change channel matches the input channel on midiCurve... not very useful since that can be different per preset.

for now i made program change work on all channels (uploaded at same link), but i could also:
- make the input channel the same across all programs
or
- have a separate setting for the pc channel to use
or something else?

when i combine midiCurve and midiPBCurve i can also think about adding conversions.

[-PIKU-]

bug report: when a fxp file (preset) is saved and reloaded, the curve is not updated correctly and even if adjusted will not be saved correctly with the project
(i'm using xt2 and xt1 as host)

[insertpizhere]

thanks, should be fixed now:
http://thepiz.org/pizmidi/midiCurve.zip

[nym]

curve seems to put a lot of stress on reaper sometimes.
i don't have a reproducible bug report but there's some strangeness.
works extra hard, i have a hunch it might be a gui thing.
perhaps happens more w/ some vstis than others

[insertpizhere]

is it from reaper saving an undo state when you move a point? or is it just when displaying the last message?