Pitch tracking to osc in Zebrify?

[gmm]

Hi experts,

I'm trying to have the internal osc of Zebrify exactly track the pitch of external signal and I fail.

I can't seem to figure out how to set the values for this properly. I figure it's just a matter of correct numbers for all parameters, but I get them wrong all the time/slightly confused how modulation works (sometimes 12 is an octave of pitch, sometimes it is not?).

I expect, if I set the Pitch Tracker LowNote and HighNote to full min and max, and then modulate Oscillator Tune with the PitchTrk at maximum, that should give a direct translation of relative pitch, but it does not. I observe Lownote and Highnote has min and max 0 and 100, while Osc Tune has min -48 max 48. Something breaks there I think, 96 and 100 does not match up.

Anyone got a clue to what settings would give a straight osc pitch follower?

[Urs]

In the "Midi" tab, left of the keyboard control, change KeySource from "MIDI" to "Input" or "Input Quantized"

That'll do the trick, no need to add any modulation source anyway.

(It might be an unexpected way of doing it though)

[gmm]

Oh, that was pretty obvious once you knew it! Thank you!