No Sound From Uniwire?

[ataraxia]

I've got a couple of Uniwire instruments on Ableton and the MIDI is getting to the Receptor and the Receptor is playing it, but there's no sound being returned to the computer?

If I plug headphones into the Receptor I get sound, any reason for this?

[batgab]

The first thing that comes to mind is that you should check to ensure that your Receptor output matrix setting matches the Uniwire GUI's setting. What I mean is, if your Uniwire GUI is set to "Receive Audio From Master Channel", make sure your Receptor VSTi channel is set to output to the Receptor's master outputs.

[ataraxia]

I've just got a new computer so settings on Receptor and the project in Ableton haven't changed at all? It worked on the last computer?

[batgab]

What about the settings in the Uniwire plugin GUI that's on your new computer?

[ataraxia]

You mean via Ableton? All is fine I can't see an option for audio from master channel, there are three instruments using Uniwire, each one using a different channel on the Receptor and taking the audio from that channel.

Picture didn't show properly, see here:

http://i1192.photobucket.com/albums/aa3 ... titled.png

[batgab]

ataraxia, I think you can ignore my previous post about your Receptor output matrix settings. If you are trying to send/receive on Receptor channel 5 (as shown in your picture), I think you may need to set your Receptor channel 5 MIDI to listen to MIDI channel 1 or "All". This seems a little odd, you'd think you'd want to set it to listen to MIDI ch 5, but if you do you get no output!

The Receptor manual says that when you use Uniwire to send MIDI data to a single Receptor channel, as you are apparently trying to do, that Receptor MIDI filter channel is bypassed by default. I'm not so sure it does that. Maybe there's an update on Muse's website, or I'm misunderstanding something. Anyway, try what I suggested and also take a good hard look at the Uniwire supplement to the Receptor manual.