Ace,highpass filter in the signal path?
-
- KVRist
- 314 posts since 27 Nov, 2009
Hi guys, is there a highpass filter on ace output (maybe to remove offset)? cause when i look at the waveform it look highpassed ,the problem is it make me loose lot of heardroom when i make saw bassline.if there is filter would be great to have a option to turn it off.
-
- u-he
- 30217 posts since 8 Aug, 2002 from Berlin
Yes, there's a highpass at about 10Hz to remnove possible DC-offsets (and patching makes for some magnificent DC-offsets...)
Bass should however be audible at any reasonable range, including the ones that you can only feel in your stomach. Give me a shout if it isn't so, I havn't tested ACE in a club yet...
Urs
Bass should however be audible at any reasonable range, including the ones that you can only feel in your stomach. Give me a shout if it isn't so, I havn't tested ACE in a club yet...
Urs-
- KVRist
- Topic Starter
- 314 posts since 27 Nov, 2009
thanks urs for the answer,when checking a saw waveform at the output it don t look the same as on ace oscilloscope ? maybe it s me who made mistake when checking i dont know, it look like a saw highpassed is it normal ?
-
- u-he
- 30217 posts since 8 Aug, 2002 from Berlin
There may be a highpass behind the oscilloscope, in the fx-section... I can check on Tuesday when back in the office...
-
- KVRist
- Topic Starter
- 314 posts since 27 Nov, 2009
thanks urs, anyway it s not a problem for the sound that is great 
but the phase shift take lot of headroom when doing some simple saw bassline,it make the sound peak way higher than it should, but it s maybe me who did something wrong, i have to check it again..
but the phase shift take lot of headroom when doing some simple saw bassline,it make the sound peak way higher than it should, but it s maybe me who did something wrong, i have to check it again..