u-he

AlexA · Post by **AlexA** » Mon May 02, 2011 7:30 pm

Would be good… or the ability to detune the sub-osc and octave (or even two) relative to VCO1

I was trying to re-create a patch I use in Sylenth but it can't be done as ACE stands at the moment!

Thanks

PaulSC · Post by **PaulSC** » Mon May 02, 2011 8:26 pm

Click on "semi' and set the coarse pitch mode to "partial" instead. To get even more range use one osc in "subharm" and the other in "partial" mode.

justin3am · Post by **justin3am** » Mon May 02, 2011 8:36 pm

Also, remeber you can use the LFOs as audio rate oscillators.

In my experience, sub-oscs can't be detuned from the oscillator that clocks them. Sub-oscs usually aren't a real oscillator just a square wave subdivision of a primary oscillator.

Urs · Post by **Urs** » Mon May 02, 2011 8:37 pm

Sub Osc can be two octaves down...?

But of course, Partial/Subharm should do the trick! If not, choose "multiply" on the fine-knob (which isn't really fine then...)

Howard · Post by **Howard** » Mon May 02, 2011 10:37 pm

...and if you need an extra LFO after using one or both as audio-oscillators, use the ramp generator. ACE is deep...

u-he

KVR Audio

Wider pitch range for the oscillators in ACE