Turnado Crashing in NI Maschine

[aikighost]

Just to report that the Turnado demo doesn't appear to be stable in Maschine on windows 7.

My install of Maschine never crashes with any of my other regular plugins (NI Komplete synths, Massive, The Finger, uHe ACE, d16 Phoscyon, Absynth, reaktor 5.5, etc.) but the Turnado demo kills my Maschine session fairly regularly.

Anyone else experiencing this in NI Maschine?

[taoyoyo]

Didn't have a problem this end with the demo inside Maschine... but I'm on a Mac, so not sure if that helps or not.

[musikmachine]

No not a singke crash with the demo. Are you doing lots of automating?

[aikighost]

No not a singke crash with the demo. Are you doing lots of automating?

Yep. Lots of automating, using the Auto write key. Otherwise what would the point be?

[musikmachine]

I was asking so i could try and reproduce it as i haven't used it much.

Been solid as a rock when i have though. Anyway just set up a loop and automated 6 of the knobs on a few patterns. Then i tried automating the dictator knob like a maniac but maschine defiantly stayed open. Can't get it to crash...

[Sugar Bytes]

I also tested on Maschine, Win7, a lot without a single problem.
If you experience crashes, please try to describe them as good as possible,
crash logs are the best to find out where the problem is,

best
Rico

[aikighost]

I also tested on Maschine, Win7, a lot without a single problem.
If you experience crashes, please try to describe them as good as possible,
crash logs are the best to find out where the problem is,

best
Rico

Hi Rico, where are the turnado logfiles stored? Ill happily send some logfiles to you to look at.

Luck,