rig kontrol 2 foot controller for guitar rig 2
-
- KVRer
- 9 posts since 20 Jan, 2007
i just purchased a receptor and i want to buy guitar rig 2, but i dont know if i should buy the software edition or the one that comes with a foot controller. it was depending the abillity to hook up the foot controller to receptor. can someone tell me if you can, and how? would it be through the USB port? thanks
-
- KVRian
- 571 posts since 14 Oct, 2004 from UK
The foot controller cannot work with the Receptor as it needs drivers.
-
- KVRist
- 90 posts since 6 Aug, 2004 from United States
I've used the Behringer FCB1010. I havent honestly played with it a ton, but from what I can tell, it will do it all. It takes a lot of finessing but since its a true midi controller, everything is assignable.
I'll give it a shot here in the next few days and try to report back.
I know that people have used the FCB1010 to control Guitar Rig on a PC/MAC and this should be no different, just routing the MIDI to the Source effect, not to the globals.
I'll give it a shot here in the next few days and try to report back.
I know that people have used the FCB1010 to control Guitar Rig on a PC/MAC and this should be no different, just routing the MIDI to the Source effect, not to the globals.
-
- KVRer
- 18 posts since 13 Jan, 2009 from Singapore
I think muse have let us down here. Rig Kontrol has been around for a while and considering Guitar Rig and the receptor is pushed as a serious mobile guitar solution, it's disappointing they have not found the time to adapt the driver for NI's own hardware. 
-
Kevin@MuseResearch Kevin@MuseResearch https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200693
- MUSEician
- 188 posts since 11 Feb, 2009
I have had success in the past using the FCB1010 for with Guitar Rig on Receptor. I used the buttons for patch changes, and then the expression pedals for modifying various parameters within Guitar Rig. It worked great, although I will say you've gotta have some MIDI programming chops to get the most out of the FCB1010... There is no friendly graphical interface like you get when programming the Rig Kontrol.
- Kevin
- Kevin
-
- KVRist
- 86 posts since 19 Jan, 2006
Kevin, or anyone else out there that has used this combination .............Kevin@MuseResearch wrote:I have had success in the past using the FCB1010 for with Guitar Rig on Receptor. I used the buttons for patch changes, and then the expression pedals for modifying various parameters within Guitar Rig. It worked great, although I will say you've gotta have some MIDI programming chops to get the most out of the FCB1010... There is no friendly graphical interface like you get when programming the Rig Kontrol.
- Kevin
How do you connect the Receptor to your amp, so that the Guitar Rig modelling software can be amplified through it ? Is it absolutely necessary to use something like the FCB1010 or will other MIDI controllers do the job ?
Is NI's own Foot Kontrol still not compatible ? An earlier post suggested it won't work with a Rceptor because of a driver issue.
Any help with connections for this particular set up would be most appreciated !
Peter