u-he

Esgalachoir · Post by **Esgalachoir** » Sun Aug 21, 2011 5:28 am

I was wondering...
What are the two keyfol modulators?(keyfol and keyfol 2)
They definitely don't seem to correspond to any of the four key follow editors for the oscillators, or for the FM key follows for that matter either. Is there a way you can edit them? I've been looking up and down through my Zebra and I can't seem to find them. Also looked in the manual, and I can't find anything on them in there either. Am I blind?(It's what my Mother would tell me) Or is it just not possible?

- Corin

Howard · Post by **Howard** » Sun Aug 21, 2011 10:09 am

"Key Follow" is proportional to the played MIDI note. The difference between KeyFol and KeyFol2 is that the Glide rate of the latter is determined by the "Glide2" offset. BTW: Glide2 is generally applied to even-numbered modules (OSC2, OSC4, FMO2, FMO4, XMF2 etc.).

Esgalachoir · Post by **Esgalachoir** » Sun Aug 21, 2011 8:30 pm

Alright, got it.
Your answer brings up another question for me.
You can't change which modules glide2 affects, can you?
Just checked the manual and it doesn't sound like you can, but I'd might as well make sure.

Thanks Howard!

- Corin

Howard · Post by **Howard** » Sun Aug 21, 2011 9:56 pm

Esgalachoir wrote:Alright, got it.
Your answer brings up another question for me.
You can't change which modules glide2 affects, can you?
Just checked the manual and it doesn't sound like you can, but I'd might as well make sure.
Thanks Howard!

- Corin

Yes... use the KeyFol2 modulator!

Esgalachoir · Post by **Esgalachoir** » Mon Aug 22, 2011 4:05 am

Howard wrote:
Esgalachoir wrote:Alright, got it.
Your answer brings up another question for me.
You can't change which modules glide2 affects, can you?
Just checked the manual and it doesn't sound like you can, but I'd might as well make sure.
Thanks Howard!

- Corin
Yes... use the KeyFol2 modulator!

u-he

KVR Audio

Silly question concerning the key follow modulators.