Hello,
I have 2 questions about MStereoProcessor:
1. Can it be used while mastering? After all, it doesn't destroy monocompatibility.
2. If it can be used while mastering and a typical mastering chain looks like this:
Compressor --> EQ --> limiter
Where should I put the MStereoProcessor?
Greetz,
manducator
MStereoProcessor while mastering
-
- KVRAF
- 1800 posts since 10 Feb, 2007
-
- KVRist
- 253 posts since 11 Jul, 2007 from Berlin
I'd suggest to put it early in the chain. If you use the exciters etc it'll add lots off transients. Maybe Vojtech will suggest you something else 
-
- KVRian
- 1371 posts since 21 Oct, 2004 from New England Transplant to West LA
Oh it can "mess" with mono compatibly. As any full featured stereo enhancer should if abused.
Keep your eye on the phase scope & learn what to listen for.
This is my current ITB chain (usually)
mautoequalizer
mstereoprocessor
mmultibandtransient
mmultibanddynamics
FX-G
Keep your eye on the phase scope & learn what to listen for.
This is my current ITB chain (usually)
mautoequalizer
mstereoprocessor
mmultibandtransient
mmultibanddynamics
FX-G
"Any experiment of interest in life will be carried out at your own expense." http://rhythminmind.net - http://signaltonoize.com
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Agreevieris wrote: This is my current ITB chain (usually)
mautoequalizer
mstereoprocessor
mmultibandtransient
mmultibanddynamics
FX-G
, but I'd use MDynamicsLimiter or MMultiBandLimiter instead of FX-G 
But note that all the dynamic processors after the MStereoProcessor may change the stereo somehow (compressors usually make it tighter).