KVR Audio

JJBiener · Post by **JJBiener** » Tue Nov 22, 2011 2:44 am

Out of deference to V'ger, I have removed Reflex from my mix. It is now listed as Enigmatic 2 to distinguish it from the original.

SoulState · Post by **SoulState** » Tue Nov 22, 2011 3:24 am

In that case is Bionic Delay are allowed ?

V'ger · Post by **V'ger** » Tue Nov 22, 2011 7:08 am

Sorry, no modulated delays..

JJBiener wrote:Out of deference to V'ger, I have removed Reflex from my mix. It is now listed as Enigmatic 2 to distinguish it from the original.

Cheers. The topic of the modulation effects rule is currently being discussed here in case you want to input. Hope as many as possible do in fact.

gorgorgathgorgorgor · Post by **gorgorgathgorgorgor** » Thu Nov 24, 2011 9:27 pm

Gorgorgathgorgorgor - Sonigen Off Again

I went back and forth between loving and hating this synth, hence the Title. In the end it's one I most likely won't come back to, as

it's UI kind of drives me crazy, but It has had it's moments. I hope you'll enjoy the result of my struggles!

12 instances of Sonigen

effects-

Master
Ferric TDS
Baxter EQ
Loudmax
TT Dynamic Range Meter
Blue Cat FreqAnalyst
Tracks
Loudmax (on nearly everything)
Tom HP Filter (on Kik)
Pancake (on Hat)
kitchen_sync_2 (using pan section only on "bass flute")
epicVerb (on the Drumkit)
DensitymkII (on the Drumkit

Quaoar · Post by **Quaoar** » Fri Nov 25, 2011 3:45 pm

andjac1963 wrote:
sonigen wrote:
andjac1963 wrote: Any thoughts?
I'm guessing here but what you could be experiencing is that parameters arnt automatically mapped to anything in Sonigen Modular. It reports 12 automatable parameters and it's up to you to select what they modulate in SM. You have to open the signal menu, (right click on a module) pick the target from the first menu, then go to the controllers sub menu, and pick AutoParam. If you click on the little automation icon on the resulting panel, you can select which of the 12 parameters it sources from.

It's a bit more effort than I would like it to be but it's limited because VST2.4 doesn't supporting dynamic parameter lists.

HTH
Hi Chris

Many thanks for your speedy response. I'll give this a go later. The synth appears quite a challenge to me as I've never used a modular synth before, the possibilities seem endless. Excited by the prospect though.

Cheers
Aj

Hi Guys,

I too was struggling how to automate the filter, Luckily this issue was allready adressed. Must say I like the synth, I do hope I get the track finished by wednesday (there's a still a lot of work and little time.
Good luck everybody.

key88 · Post by **key88** » Sun Nov 27, 2011 1:20 am

key88-TankingTurkey

My DAW is Reaper
11 instances of Sonigen
Effects on individual tracks, but not all tracks used the stereo enhancer:
Classic Compressor
Classic Reverb
Classic Master Limiter
Stereo Enhancer

Effects on the Master FX
Classic Compressor
Classic Reverb
Classic Master Limiter

I liked this synth and will probably use again, just wish the automation items were labeled so I knew what parameters I could adjust without digging too deep.

adam_firegate · Post by **adam_firegate** » Sun Nov 27, 2011 10:57 am

What external delay can I use?

Bjulin · Post by **Bjulin** » Sun Nov 27, 2011 11:19 am

i prefer mg tempodelay and it is allowed...

V'ger · Post by **V'ger** » Sun Nov 27, 2011 1:43 pm

Yes anything that doesn't have modulation hardwired. MgTempodelay is good as already said, as is IxoxDelay and Readelay.

bzur · Post by **bzur** » Sun Nov 27, 2011 5:47 pm

I've reuploaded my entry. In this version I replaced the (beloved

) Tal Dub II with Ixox Delay (followed by Melda Autopan), and Tal Rev II with Magnus Ambience (hope this one is not forbidden...).

I've made also some slight modifications on volumes, and some eq-ing.

Doc Jon · Post by **Doc Jon** » Sun Nov 27, 2011 6:25 pm

Spare time has been hard to find recently. It's the 27th and I still haven't started anything, looks like I may have to pass this month

Will still try and vote though

Jon

debby · Post by **debby** » Sun Nov 27, 2011 7:43 pm

sonigen wrote: To use velocity on the amp envelope you add it as a 'modifier', that means you right click on the input panel with the cable, then select the modifier from the menu.

I tried. But, velocity applied next midi note not low velocity note.

sonigen · Post by **sonigen** » Mon Nov 28, 2011 1:30 am

debby wrote:I tried. But, velocity applied next midi note not low velocity note.

Hmmmmm make sure you have the Velocity Glide turned down, its on the Master module. If that doesn't help you can email me the patch if you want.

debby · Post by **debby** » Mon Nov 28, 2011 10:41 am

sonigen wrote:
debby wrote:I tried. But, velocity applied next midi note not low velocity note.
Hmmmmm make sure you have the Velocity Glide turned down, its on the Master module. If that doesn't help you can email me the patch if you want.

Oh.. How did you know it?

Thanks.. and beta soft too..

soapform · Post by **soapform** » Mon Nov 28, 2011 10:42 am

Here's my entry:

Bogucha - Ucha Boga

10 instances. Renoise.

Effects used:

Tracks (6x) Cockos ReaJS LOSER/Exciter
Master (1x) Cockos ReaJS LOSER/MGA_JSLimiterST
Send (1x) Signaldust Abstract Chamber (Modulation 0%, if that matters)

Great synth.

One-Synth-Challenge 34: Sonigen - Submissions and gossip