u-he

ddeez · Post by **ddeez** » Tue Nov 29, 2011 10:09 am

I find it frustrating and very hard (and sometimes impossible) to read what the jacks are labeled in the modifications page when they are covered up with cables. Would it be possible to have a non cable version of the modifications page? something that would be easier to read? at the very minimum some type of setting that would make the labeling of the jacks stand out over the cables? I've noticed this in Bazille too.

Urs · Post by **Urs** » Tue Nov 29, 2011 11:55 am

That page will be designed at some point. Currently it's just, hmm, flung together.

ddeez · Post by **ddeez** » Tue Nov 29, 2011 11:57 am

thanks for the response Urs. Yeah if it could be as easy to understand/see as Zebra I'd be in heaven.

Howard · Post by **Howard** » Tue Nov 29, 2011 12:34 pm

Tip: Like in ACE, you can right-click on the target end of any cable and select e.g. "slim and see-thru".

Urs · Post by **Urs** » Tue Nov 29, 2011 12:36 pm

Howard wrote:Tip: Like in ACE, you can right-click on the target end of any cable and select e.g. "slim and see-thru".

(that's the default setting now... I think...)

u-he

KVR Audio

Diva GUI request