Uhbik-T Surround Problem in Nuendo 5

[Breeze]

I'm having some problems with Uhbik-T in Nuendo 5.2.2 32-bit in W7-64. I'm running Uhbik 1.2.

I've instantiated it on 4 5.1 group channels, fed from stereo sources and connected to 5.1 output bus. I've removed all other plugins from the project. The two problems include:

1. The auto-surround and multichannel settings doesn't seem to work; stereo in only yields stereo out. The only way I can get it to work in surround is on the mono-surround and stereo-surround settings. It used to work fine on the auto setting so this seems strange.

2. After a while, even at it's lowest setting, the haas delay creates continuous noise,like a digital overload.

The haas problem increases over time with single or multiple instances. By removing all instances and instantiating just one, I have no problem for a few minutes and then it starts. But I can get to a setting of 1.4 before the noise creeps in after that. With multiple instances the noise is still there even if haas delay is at 0, but it's very low in volume.

Very strange.

[Urs]

Eeek, strange indeed.

Stereo in should always yield stereo out in "auto-surround" and "multichannel" setting. Only Ambience and Delay use monosums in every mode. In every other plugin it's expected to use "stereo-surround" which propagates the left input to left back, right input to right back, monosum to center and Lfe.

The problem with Haas delay is new to me. Could you render an audiofile for me? That would help big time when looking into it.

Thanks,

Urs

[Breeze]

The problem with Haas delay is new to me. Could you render an audiofile for me? That would help big time when looking into it.

Thanks,

Urs

Sent. Thank you for looking into this.