Zebra knobs getting bugged, not moving ..
-
- KVRist
- 208 posts since 8 Aug, 2010 from London, UK
I am having an issue where some patches seem to get bugged and when you try to move a knob it springs back to where it was before. It's not midi learn I already tried that, any ideas ?
-
- KVRist
- Topic Starter
- 208 posts since 8 Aug, 2010 from London, UK
just to add, if I use the scroll wheel it works ok, dragging causes the knob to spring back to it's former position
-
- u-he
- 30222 posts since 8 Aug, 2002 from Berlin
hmmm... can you send us the project?
Unfortunately Fritz is on vacation. He usually does these tests. Hmmm.
Unfortunately Fritz is on vacation. He usually does these tests. Hmmm.
-
- KVRist
- Topic Starter
- 208 posts since 8 Aug, 2010 from London, UK
https://www.box.com/files#/files/0/f/0/1/f_2347026932
I am getting on the MMix const. knob, weird thing is sometimes it doesn't happen and then after a while of fiddling it does happen.
Cheers, IAYF
I am getting on the MMix const. knob, weird thing is sometimes it doesn't happen and then after a while of fiddling it does happen.
Cheers, IAYF
-
- KVRist
- Topic Starter
- 208 posts since 8 Aug, 2010 from London, UK
empty post
-
- KVRist
- Topic Starter
- 208 posts since 8 Aug, 2010 from London, UK
Urs, some info, I just had another issue with said patches and it was a midi learn issue. The problem I asked you to look at definitely did occur AFTER I unlearned the offending knob though. Just want to make sure you have all the info so I don't waste your time.
Cheers
BTW this did just give a good laugh as I realised I have a "Glitchy Knob" LMFAO
Cheers
BTW this did just give a good laugh as I realised I have a "Glitchy Knob" LMFAO