ACE - Sines & Triangles?

[Donmich]

I apologize for asking this without reading the manual yet, but I honestly have been concentrating of Diva and Zebra with the time I have had of late.

I read in a review that you can get audio rate sines and tri's out of the LFO. I would love to be able to add these to the sonic palette offered by the main VCO's.

Can anyone be bothered to tell me how this is done?

Thanks

[Sendy]

If you click on the waveforms for oscillator 1 you can switch to a triangle/parabola mix instead of pulse and sawtooth.

[xh3rv]

Click the buttons below the rate controls to get semi / sub / partial / hz / sync for time basis. Note LFO1 and LFO2 are different beasts - LFO1 is sine-shaped and does S&H and FM (well, PM); LFO2 sin/tri/saw/square/ and 'tap map'. One would have to cable the oscillators into the mixer, filter, or output to use them as audio source oscillators rather than audio-rate modulators.

Read the manual for more though

[Donmich]

Woah. Thanks,

[Howard]

... and read the manual

[Donmich]

... and read the manual

Of course.

So much U-he so little time recently. I cant wait to read it actually.

Btw, Howard as in Scarr?

Huge admirer brother.

[EvilDragon]

Yep, as in Scarr.

[MitchK1989]

Tapmap at audio rate = hilariously awesome.