This might be a stupid question but how do you get AR behaviour from the standard envelopes ?
After setting the stustain to zero, it seems that you have to fiddle with both the decay and release stages to get it just right and it can be quite tricky for very short envelopes, I find it a bit annoying.
If you set the release to zero then the decay stage is bypassed by the note off event so you get an abrupt ending unless you hold the note longer than the decay.
zebra AR envelopes
-
FastTriggerFish FastTriggerFish https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=261931
- KVRist
- 158 posts since 3 Aug, 2011 from London
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
Set Sustain to zero, Decay and Release to exactly the same values, don't use F/R or the definable stage. Tip: temporarily leave Release at zero and play long enough notes until you find the best value for the Decay... then set Release to the same as the Decay - saves lots of fiddling.
Or use MSEGs instead (if you don't need your amp envelope to be one-shot)
Or use MSEGs instead (if you don't need your amp envelope to be one-shot)
-
FastTriggerFish FastTriggerFish https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=261931
- KVRist
- Topic Starter
- 158 posts since 3 Aug, 2011 from London
I see, thanks for the tip Howard.
MSEG are great but you can't use them as the lane amp envelope.
That would actually be a nice improvement for Zebra3, as well as a switch to link the decay and release settings ?
MSEG are great but you can't use them as the lane amp envelope.
That would actually be a nice improvement for Zebra3, as well as a switch to link the decay and release settings ?
-
- u-he
- 30234 posts since 8 Aug, 2002 from Berlin
-
- KVRian
- 1116 posts since 6 Jul, 2009
Urs wrote:Yup, MSEGs will learn to do VCA duties for Z3
