MeldaProduction

Oliver.Lucas · Post by **Oliver.Lucas** » Thu Oct 25, 2012 1:45 pm

Hi,

what's the easiest way to reset the settings to factoy default?

I have the problem that the sonogram view has started to show a "comb filter" accross the entire fequency range.
It certainly did not do this before.

This is in Nuendo 5 (VST3) OS X version.

Ollie

MeldaProduction · Post by **MeldaProduction** » Thu Oct 25, 2012 10:28 pm

Hi Ollie,

so you tampered with the default settings, right? Well, then just load the preset "Default" and set it as default using Settings/Set default settings.

MeldaProduction · Post by **MeldaProduction** » Thu Oct 25, 2012 10:29 pm

Btw. can you try on multiple audio sources? I'm asking because this looks like you are analyzing something, that has delayed right or left channel.

Oliver.Lucas · Post by **Oliver.Lucas** » Fri Oct 26, 2012 8:57 am

MeldaProduction wrote:Btw. can you try on multiple audio sources? I'm asking because this looks like you are analyzing something, that has delayed right or left channel.

I have tried with various sources. Since I am dealing with voice recordings 95% of the stuff was mono.
I have deactivated "enable when hidden" and for the moment everyting seems fine again.

Ollie

MeldaProduction · Post by **MeldaProduction** » Fri Oct 26, 2012 1:28 pm

Hmmm, ok thanks for the info, I'll check this out.

MeldaProduction · Post by **MeldaProduction** » Fri Oct 26, 2012 1:34 pm

Ok, one question - how does comb filtering look? Can you send me some screenshots?

MeldaProduction

KVR Audio

MAutodynamicEQ: Reset to factory default?