New download: Automap for Zebra

[Andi_Paulo]

Hi all!

I did an automap surface for Zebra. You can control 4 oscis, 4 envelopes and 4 VCFs with it.

Parameters:

Oscillator:
vol, pan, wave, detune, FX 1, FX 2, phase, sync.
For these parameters there are also buttons to reset them and controls for the modifiers.
5 buttons for tune: otave down, oktave up, semitone down, semitone up, reset

Envelope:
Faders for att, dec, sus, F/R, rel

VCF:
faders for cutoff and resonance, button to step through the filter types

page 1: osc 1, env 1, VCF 1
page 2: osc 2, env 2, VCF 2
page 3: osc 3, env 3, VCF 3
page 4: osc 4, env 4, VCF 4

main output vol at all pages

You can find it in the KVR download section.

Some time I will do more, but this is a good start I think.

Andi Paulo

[MFXxx]

Hi Andi thanks for the share and heads up. Will give it go Anymore you care to share please I only worked out this week how to get it all working, spent a month giving up and realised Cubase and Automap wasn't interfacing due to Automap not running as Administrator

Peace

[Andi_Paulo]

Anyone tried it?

I would like to go on and implement some more modules, but I'm not very good with synths, normally I do stuff like this

(spoon spam!!)

So, I'd like to know from you:
What are the most important parameters for you?
What should be on the same page / on nearby pages?