Having problems with the VST3 version of Zebra2 and ZebraHZ

[Whirly]

I'm having the following problems with the VST3 version of Zebra2 and ZebraHZ (rev 1331):

1) Only a default wave (fin-saw-pulse) is loading. All factory OSC's and user OCS's are visible in the browser, but won't load.

2) Sometimes a whole bunch of modulation sources (4 LFO's, 2 GLFO's, 4 ModMapper, 4 ModMixer, 4 Envelopes) will appear without being assigned to any parameter, and can't be removed.

The same problems appear in both 32 bit and 64 bit host. The VST 2.4 version of both seem to be working fine. I'm on Cubase 7.01, Mac OSX 10.7.5

Anyone who recognize these symptoms and can help me solve this issue?

Thanks!

[Whirly]

I've uninstalled everything Zebra and installed again. Unfortunately, the problem still persists. The VST3 version won't allow me to pick waveforms from the browser.

1) Every time I try to change the waveform of an OSC it jumps to the Fin-Saw-Pulse, even if I'm clicking on a totally different waveform in the Oscillator Module Preset browser.

2) If I manually draw a waveform it stays there even if i pick a new waveform from the OMP browser.

Please note that patches are loaded with the correct waveform.

Cubase 7.01/Cubase 6.5 on Mac 10.7.5

[bmrzycki]

Checked to see if this is happening in Zebra2 or ZebraHZ rev 1331 on Windows and cannot replicate the error. Both load waveforms fine. If it's a bug in Zebra it seems to be confined to the mac version only.

[Whirly]

Thanks for checking. I have not seen others with a similar problem so I guess I have to troubleshoot my own setup. I just don't know where to start.