Can someone tell me how to use the extra outputs on MuDrum or MutuSampler.
Please .. I have e.g routing a kick thru audio output 1 and a snare thru output 2 .. Connected them up
in a deep session but the snare does not seen to come out anywhere????
Thanks H
Outputs
-
- KVRer
- 2 posts since 31 Jan, 2013
-
- KVRian
- 855 posts since 3 Mar, 2009
Let's focus on MuDrum first:
In the relevant Mudrum rack click in the lowest slot, where it says "Audio Output", and select "Output 2" or 3 or 4.
If Mudrum is in a Mulab rack, you can't access the extra outputs.
If Mudrum is created in the Session MUX, connect the extra outputs to any of the Mulab racks you see in the Session MUX.
Done.
The same applies to the Multi Sample Player Module.
Open the Multi Sample Editor (the one with the keyboard on top and the sample ranges below). For each sample you want to re-route right click on the relevant sample in this editor and select "Edit Zone Details". In the bottom right of this window you find "Output". Change to 2, 3 or 4.
Again route the extra outputs in the session MUX to Mulab Racks or (hardware) Audio Outs.
In the relevant Mudrum rack click in the lowest slot, where it says "Audio Output", and select "Output 2" or 3 or 4.
If Mudrum is in a Mulab rack, you can't access the extra outputs.
If Mudrum is created in the Session MUX, connect the extra outputs to any of the Mulab racks you see in the Session MUX.
Done.
The same applies to the Multi Sample Player Module.
Open the Multi Sample Editor (the one with the keyboard on top and the sample ranges below). For each sample you want to re-route right click on the relevant sample in this editor and select "Edit Zone Details". In the bottom right of this window you find "Output". Change to 2, 3 or 4.
Again route the extra outputs in the session MUX to Mulab Racks or (hardware) Audio Outs.
-
- KVRer
- Topic Starter
- 2 posts since 31 Jan, 2013
Sound .. Thanks .... It works very nicely just as you say with MuDrum ... however when I put a MultiSampla in the Session Mux it shows up with a single audio output only and again when I select outputs 2,3,4 for a sample they do not sound.
Scratch that .. I found it in ..Others.. excellent!!!!
Scratch that .. I found it in ..Others.. excellent!!!!