How to get the original parameter values back

[janamdo]

For automations of parameter it is needed sometimes to restore the default value of the parameter back.
How i do get this in MUlab/Mux ?
( note : i searched in the manual, but it is difficult to find it )

[sl23]

I don't think it's possible, at least, I've been trying to find out but can't find a way to do it. This is one thing I liked on the original Electribe series, where, as you adjust parameters if the parameter value hits the default settings for a patch it lights an LED. Hopefully something like this will make it's way to the MuX?

[MuTools]

You can [Alt]+click parameters to set them to their default value.