u-he

Bender-Offender · Post by **Bender-Offender** » Tue Aug 13, 2013 4:44 am

Hi,

As the title says, I can't move saved patches from the right side in the patch browser to the left side to put in a folder when I'm using Zebra in Cubase 7 & 6. I've tested this in Logic and it works fine. I've also tested this on two separate computers ending with the same results.

I'm running Mac OS 10.8.4 with Cubase 7.0.4 & 6.5.5.

Thanks for the help.

Urs · Post by **Urs** » Tue Aug 13, 2013 7:37 am

Hmmm... are you using 32bit or 64bit versions of Cubase? The 64bit version of Zebra would use the same code as the AU for the interface while the 32bit version is stuck on legacy code.

Also, what revision number is printed right below the XY controls?

chokehold · Post by **chokehold** » Tue Aug 13, 2013 9:03 am

Also interesting: VST3 or VST2?

EDIT:
Just tested with Rev 1766 ... OSX 10.8.3 and Cubase 6.5, 32 and 64 bits, VST2 and VST3 (also AU in AULab)
No problems reorganizing by dragging patches from the right list to folders in the left list.

Bender-Offender · Post by **Bender-Offender** » Tue Aug 13, 2013 4:30 pm

Urs wrote:Hmmm... are you using 32bit or 64bit versions of Cubase? The 64bit version of Zebra would use the same code as the AU for the interface while the 32bit version is stuck on legacy code.

Also, what revision number is printed right below the XY controls?

Hi Urs,

I'm using 64-bit versions of Cubase.

The revision is Rev1560.

Thanks for the help!

Bender-Offender · Post by **Bender-Offender** » Thu Aug 15, 2013 3:37 pm

bump.

I'm starting a new project where I'll be creating many of my own Zebra patches, and to not be able to organize them properly will be a major bummer.

I've tried both VST2 and VST3 versions of Zebra yet neither work still. Same goes for the "Reveal in Finder" command.

Thanks for your help.

Urs · Post by **Urs** » Thu Aug 15, 2013 8:20 pm

Seems like it's fixed here... I'm not sure if it's "safe" to release beta versions for the next round of updates though. We had some possible crash bugs lately. I'd rather do that in September.

Bender-Offender · Post by **Bender-Offender** » Fri Aug 16, 2013 9:09 pm

Urs wrote:Seems like it's fixed here... I'm not sure if it's "safe" to release beta versions for the next round of updates though. We had some possible crash bugs lately. I'd rather do that in September.

Hi Urs,

Thanks for the reply. I don't know why I didn't try this earlier, but I'm able to move the patches when Cubase is in 32-bit. So it's in Cubase 64-bit that I'm not able to move them. The problem is is I have a lot of plugins in Cubase and need to run it in 64-bit.

Thanks for the help.

u-he

KVR Audio

Can't move Zebra patches when in Cubase