Newbie question - how are the two oscillators in each layer combined before filtering?

[Wibbs]

Hey,

So I've looked through the quickstart guide and can't find an obvious answer to this. Basically, if you both oscillators in a layer active and producing a sound, how are they combined before they reach the filter stage? Does one modulate the other, or are both sounds passed through individually?

Thanks,

Wibbs

[kv331]

We show the routing graphically, it depends totally on your filter routing:

Series: Osc2 is added to Osc1, the mix is sent to the filters



Parallel: Osc2 is added to Osc1, the mix is sent to the 2 parallel filters.



Split: Osc1 is connected to Filter1, Osc2 is connected to Filter2.



Osc2 does NOT modulate Osc1 in any way. The modulators are used to modulate the oscillators instead.