u-he

quadrant · Post by **quadrant** » Wed Oct 02, 2013 6:18 pm

Not sure if this has been mentioned before... the chorus on Diva is amazing, but it would be wonderful if there was a knob that controlled a crossover frequency, below which the effect wasn't applied. I use the chorus effect a lot for bass sounds, and detuning/stereo isn't always desired in the lower registers.

Sendy · Post by **Sendy** » Wed Oct 02, 2013 6:23 pm

I'd certainly welcome a HPF in the chorus panel to drain off some of the lows of the wet signal. (In fact, I've found most delay-based effects benefit greatly in mixability from even a simple HPF or low cut).

quadrant · Post by **quadrant** » Wed Oct 02, 2013 8:46 pm

Yeah, for sure. I mean I can fake it by bouncing a dry and wet, and just laying it out over 2 tracks, but one knob sure would be easier

maurone dj · Post by **maurone dj** » Wed Oct 02, 2013 8:50 pm

u-he

KVR Audio

Diva feature request - crossover for chorus