Hi,
also in older versions of MuLab I noticed the following effect:
The module "mono echo (short)" slightly delays the signal even when delay time is set to "0.000 ms". In my new "phasing" patch this leads to a considerable cutting-off of high frequencies. I think zero has to be zero. (I made a workaorund in my patch, but this requires one more automation track.)
Any chance to solve this?
JR
Mono echo module (not a feature)
-
- KVRist
- 409 posts since 26 Jul, 2010 from Germany
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
Indeed currently the minimum delay is limited to 1 sample. Is that a prob? (apart from the fact that the display should reflect that, agreed on that)
Practical note: Tomorrow & thursday i'll be offline most of the time. Talk soon.
Practical note: Tomorrow & thursday i'll be offline most of the time. Talk soon.
-
- KVRist
- Topic Starter
- 409 posts since 26 Jul, 2010 from Germany
Good workaround. Thanks a lot. (Had the same idea under the shower this morning ...)AndreasD wrote:Put a Pure Delay with 1 Frame delay in the other channel?
Andreas' suggestion is absolutely sufficient. (Although a correction of the displayed time would be perfect.)mutools wrote:Indeed currently the minimum delay is limited to 1 sample. Is that a prob? (apart from the fact that the display should reflect that, agreed on that)
JR