CC control parameters per voice?

[DrRefract]

I have a Keith McMillan QuNexus (great little controller!) and I'm working out how to use it with Zebra2 and Diva.

One of the QuNexus's strengths is that it has not only aftertouch, but a Tilt feature that continuously registers the finger position on each key/pad. It's like a mod wheel built into each key.

My goal is to map this parameter to the Diva and Zebra2 in such a way that tilt can control per-voice parameters, e.g., a filter cutoff (which, at a given moment, can be in different positions for different notes, as in when it's shaped by an envelope).

I'll need to work with the QuNexus's Channel Rotation function to make this happen. But I need a better understanding of how to map per-voice parameters in Zebra2 in general, i.e., send a MIDI signal to the filter cutoff that says "Adjust this separately for each voice--don't just change it for all active voices at once."

Thanks in advance!

[xh3rv]

I think only PolyAT MIDI is really specified to work this way. I can't think of anything off-hand other than multiple Zebras. With DIVA I wonder if the voice-mod knobs might work. If Channel Rotation matches the voice assignment logic in DIVA, one could MIDI-map sort of in parallel channel # & voice #.

There are some other QuNexus users that visit this forum, might have a better sense of things.