A straight forward application for the new module is the Rectifier.
This can use only the positive half of the audio (1 diode ->1D) or the full signal by flipping the negative half of the audio to positive using a bridge rectifier (Bridge).
Note that early stomp boxes used this technique as a simple octaver. Send a sine wave into it and switch from 1D to Bridge to see the effect.
Some new versions for the amp/speaker simulations, with some additional tones. I basically changed the "amp" only and let the filter network as before. That's why they are v2 now.
Finally a Parallel EQ with bell shapes.
As with the previous parallel EQ, the phase shift is less than half compared of the usual EQs. To me it sounds more open and transparent, but that could just be my imagination
Because of the peculiarities of parallel EQs, i split things in separate cut and boost filters. So this one is actually 4 bands. 2x cut plus 2x boost.
Gain is only +-6dB!
Zip file is HERE
Enjoy!
P.S.: I want to make an exiter, but my current results are not as expected. Can anyone point me to a good VST Exiter, for me to find out what i'm doing wrong?
Thanks!