Hey guys,
I go into settings and disable high quality upsampling and set automation CPU protection to minimal. I did this for every plugin. However, when I open projects the settings nearly always are reset to their standard values. Is this a bug?
Thanks
Settings revert themselves all the time
-
- KVRAF
- 1758 posts since 15 Mar, 2013 from Germany
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Hi,
which version and host are you using? I tried with prerelease 8.00 and it seems fine. I'm not sure about the beta though, but I don't remember any changes in that.
which version and host are you using? I tried with prerelease 8.00 and it seems fine. I'm not sure about the beta though, but I don't remember any changes in that.
-
- KVRAF
- Topic Starter
- 1758 posts since 15 Mar, 2013 from Germany
I am still on 7.13
I didn't check the settings in every session, so I don't know if the settings are lost immediately. But after a certain time they always show the default values. I will try if it happens immediately or if I can isolate what causes this.
I didn't check the settings in every session, so I don't know if the settings are lost immediately. But after a certain time they always show the default values. I will try if it happens immediately or if I can isolate what causes this.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122
- KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Ok. The major update should be out in a few days, so hopefully that will help anyway 
.
.