MeldaProduction

Svama · Post by **Svama** » Sun Jun 01, 2014 8:41 pm

Hi Vojtech,

is it right, that there is no bypass for your two red vertical lines (high and lowpass filters). Please, please, add this feature or call me how to do it.

Thanks and greets

Marek

DarkStar · Post by **DarkStar** » Mon Jun 02, 2014 8:33 am

Can't see an "Bypass" switch - perhaps Vojtech can add an "Off" setting to the top of the list of values?

MeldaProduction · Post by **MeldaProduction** » Mon Jun 02, 2014 9:29 pm

Sorry guys, but no, there's no place for it and there's no need to it. The filters are bypassed when in the extreme positions (20Hz or 20kHz). If you want a bypassable filter, then just use a band

.

DarkStar · Post by **DarkStar** » Tue Jun 03, 2014 9:20 am

Yes, if, for example, I had this setting:

I can defeat it by dragging the red line all the way to the left. To enable it again I need to drag the line back to 50.4 Hz and that needs a bit of "mouse-jiggling". It would be easier, imo, to drag the [HP 12] to "Off" to disable it then back to [HP 12] to enable it.

And similarly for the [LP 12].

MeldaProduction · Post by **MeldaProduction** » Tue Jun 03, 2014 9:23 am

Yes, I understand, but sorry, there's no space and if you need to do that, you can use the bands, which you CAN disable. These filters are there for convenience as one does that almost for every track during mixing.

MeldaProduction

KVR Audio

Missing bypass for mdynamiceq and mautodynamiceq