Hello,
I DL'ed the demo and am likin what I see so far. I am GLAD there is no fumbling DX or Dxi,...only Rock Solid VST FX and VSTi. However,...I am using Waves RennMaxx and am seeing some funky things happen.
I set a long loop, then set Automation to Rec and open RenEQ and just start going wild. It works fine for a while then...something happens and the vol lowers/drops (the EQ graphic too) It's not what I did in the automation. If I keep it simple,..it seems fine.
Also,...I am used to having a master bus with changable routing. (Like moving an EQ or compression BEFORE or AFTER the master Vol) Is that possible?
Thanks
automation and other question
-
- KVRAF
- 3441 posts since 15 Mar, 2003
Not possible in the master.
However, you can route all of your tracks to one of the regular tracks and use that as a master (sub-master) and then route that to the master out.
Now, using the regular track as if it were the master, you can move the effects pre or post volume, or put the meter anywhere you like, etc.
However, you can route all of your tracks to one of the regular tracks and use that as a master (sub-master) and then route that to the master out.
Now, using the regular track as if it were the master, you can move the effects pre or post volume, or put the meter anywhere you like, etc.